Cut dialog

The Edit > Cut Special command opens the Cut dialog box, which lets you remove from the project and put on the Clipboard any selected objects. You can paste the contents of the Clipboard elsewhere. See Paste dialog.

The Cut dialog box has the following fields:

Events in Tracks

If you select this check box, Sonar removes every Event in the selected object.

Clip Automation

If you select this check box, Sonar removes all clip automation in the selection.

Track/Bus Automation

If you select this check box, Sonar removes all Track and Bus automation from the selection.

Tempo Changes

If you select this check box, Sonar removes all tempo changes in the selected object.

Meter/Key Changes

If you select this check box, Sonar removes all meter and key changes in the selected object.

Markers

If you select this check box, Sonar removes all markers in the selected object.

For more information, see Moving and copying clips.

Arranger Sections

If you select this check box, Sonar removes sections in the active Arranger track.

All Arranger Tracks

If you select this check box, Sonar removes sections in all Arranger tracks.

Delete Hole

If you select this check box, Sonar uses ripple editing (Ripple Edit Selection) to close the gap that results after deleting the current selection.

Shift by Whole Measures

When Delete Hole is selected, also select Shift by Whole Measures if you want the data that comes after the hole to retain its same relative placement in a measure

 

See also:

Erasing tracks