Properties Inspector - Bus Properties

The Bus Properties Inspector lets you type a name, specify the automation time base and write mode, and enter a text description for the bus(es).

Figure 302. The Bus Properties Inspector lets you specify settings for the selected bus(es).

A. Dock/undock Inspector B. Show/hide Bus Properties Inspector C. Bus name D. Arranger exclude E. Automation Time Base and write mode F. Text description

To show/hide the Bus Properties Inspector

Click a bus in the Track view, then click the Show/Hide Bus Properties button at the top of the Inspector pane, or press CTRL+SHIFT+I.

Figure 303. Click the Show/Hide Bus Properties button to show/hide the Bus Properties Inspector.

 

Note: If the active channel strip is a track, the Track Properties tab label shows Track instead of Bus .

The Bus Properties Inspector contains the following sections:

Properties section

Track Name. Assign a name to the selected bus.

Arranger Exclude. Prevent the bus data from being selected when you select an Arranger section.

Automation section

Time Base. Choose one of the two options in this section to control what happens to automation when you change the tempo:

Musical (M:B:T). If the bus is set to the Musical time base, the automation’s M:B:T position stays constant, and its absolute position shifts.

Absolute. If the bus is set to the Absolute time base, its absolute position stays constant, and its M:B:T position shifts.

Write Mode. This drop-down menu lets you choose the automation write mode:

Touch. Touch mode overwrites any existing automation data for the currently armed parameter only when the parameter is moved with the mouse or a MIDI controller. Automation writing stops when the parameter is released, and the parameter returns to any previously automated position.

Overwrite. Overwrite mode overwrites any existing automation data for the currently armed parameter while the transport is rolling, even if you don’t touch the parameter.

Latch. Latch Mode is similar to Touch mode; new automation data overwrites existing automation data when you move a control. However, when you release the parameter, it will remain “latched” into its current position and continue to overwrite any existing automation data until playback stops.

Description section

Description. Type a comment or description of the selected bus.

 

See:

Properties Inspector - Clip Properties

Properties Inspector - Track Properties

Inspectors