The following installer will install version 1.0.0.4 of the VS-20 Control Surface Plug-in onto your computer. This installer is required to use the V-Studio 20 hardware with other Cakewalk hosts aside from Guitar Tracks 4, such as Guitar Tracks Pro 4, SONAR Home Studio 7 or SONAR Producer/Studio/Essential.

New Features and Issues Addressed:

• New in 1.0.0.4 - Resolved an issue where main output would only control the left side of main output when an audio device is reconnected
• There is now a 64-bit Control Surface Plug-in for controlling SONAR x64
• Resolves an issue where arming a track would re-assign the track's input if the VS-20 was enabled as a control surface

Installation & Setup Instructions:

1. Click the link below to download the V-Studio 20 Control Surface Installer
2. Save the installer to your desktop
3. Locate and run VS20_CSP_Win.exe
4. Choose whether or not you want to install the 32-bit or 64-bit Control Surface plug-in.
5. Follow the on screen instructions and click [Finish] at the end of the installer
6. Configure your Cakewalk host to use the VS-20
   1. Go to Options | MIDI Devices and enable the "VS-20 DAW Control" under both Inputs and Outputs
   2. Go to Options | Controllers/Surfaces
   3. Click the "Add New Controller/Surface" button
   4. Assign Controller/Surface to "VS-20"
   5. Assign the Input Port and Output Port to "VS-20 DAW Control"

Download the V-Studio 20 Control Surface Installer (Approx. 14 MB)