Cakewalk // Documentation // Cakewalk // AudioSnap
Table of Contents Previous Next Index


AudioSnap works by finding the transients in audio clips. Transients are the areas in an audio clip where the level increases suddenly. These make good locations to shrink, stretch, or split a clip, without changing its sound quality too drastically. Cakewalk contains a variety of high-quality stretching algorithms for different kinds of material. You can choose a lower-quality algorithm for real-time playback of your edits, and then choose a better algorithm for mixdown or bouncing to track (see Algorithms and rendering).
Figure 352. Audio clip.
If you want to edit audio right away with AudioSnap, see Synchronizing audio and the project tempo and Fixing timing problems in audio clips. If you want to learn more about all the AudioSnap tools and options, see the following links.
The AudioSnap transient detection method can be specified in Edit > Preferences > Project - AudioSnap under Transient Detection. There are three methods:
Spectral (default for legacy projects)
Multi-Resolution (default for new projects)
Multi-Resolution is the default transient detection method for new projects, and Spectral and Magnitude are the older legacy modes. The Multi-Resolution transient detection algorithm provides improved transient analysis that works well with most audio source material.
The detection mode is stored in the project and older projects will continue to use Spectral until changed via Edit > Preferences > Project - AudioSnap.
Note: The Multi-Resolution transient analysis will not be used by default on pre-Cakewalk 2021.09 saved projects. You must explicitly pick the Multi-Resolution algorithm from Edit > Preferences > Project - AudioSnap before this will take effect for that project. Once you resave the project with this change it will continue to use the new algorithm for all audio.
When the detection method is changed, you will be prompted that project audio waveforms will be recomputed. After regeneration of the waveforms are complete, the new transients will be visible when switching the edit filter to Transients. The default transient threshold (available in the AudioSnap palette) is different for each transient detector mode. Note that any edited transients are retained when switching the transient detector mode.
Copyright © 2024 Cakewalk, Inc. All rights reserved
Sitemap | Privacy Policy | Legal